Samsung SDS SHS-3320, User Manual

Page: 8 / 36

Samsung SDS
Digital Door Lock
SHS-3320/3321
5. Connecting the cable
1. Connect the cable from the exterior unit to
the interior unit.
2. After connecting the cable, push the cable
into the hole of the door.
C
B
4. Installing the Magnetic Sensor
3/4˝(20mm)
R
ig
ht
T
rig
ge
r
Left Trigger
Left Trigger
R
ig
ht
T
rig
ge
r
Install the door side magnetic sensor.
It should be installed in right way of the door.
CAUTION : The gap of the magnet sensors
between the door side and the door-frame should
be within 3/4”(20mm). If the gap is to wide, pull out
the door side magnetic sensor to adjust the gap
enough to detect.
3. Installing the Mounting Plate
1. Detach the Interior Mounting Plate from
the interior unit.
2. According to the right or left handed door,
adjust the link, and attach the mounting
plate.
3. Fasten the interior mounting plate with
three TH+M5x40 (H2) 90% of the way.
4. Align the Exterior Unit with the Interior
Mounting Plate and then tighten the
screws.
5. Cover the rubber pad on the Interior
Mounting plate.
CAUTION : Do not over-tighten, and check
the movement of dead bolt by the mechani-
cal key.
D
Right-handed Left-handed
D
H2