English -
15
INSTALLATION STACKING
In case of purchasing the additional stacking kit, contact our Samsung service center or local
distributers. [Part no. SK-DH / SK-DA]
1.
Carefully lay the dryer on its side. Use the packing material
so you don’t scratch the finish on the dryer.
2.
Install rubber pads to dryer base.
• Locate the 4 rubber pads in the parts package. Insert
the rubber pads into the holes at the bottom of the
levelling legs.
• Purchase the stacking-kit package additionally.
3.
Set the dryer upright.
The stacking kit can only be installed for Samsung family products.
4.
Install bracket to dryer.
• Remove washer top cap screw from the rearleft.
Align left bracket holes with top cap screw hole on
rear left of the unit and replace screw.
Leave screw loose so dryer hole alignment will be
easier.
• Repeat the above step with the right side.
5.
Install dryer and bracket on washer
• Lift the dryer on top of the washer. Protect the washer
control panel with cardboard or other protection. Be
sure to lift the dryer high enough to clear the washer
control panel.
Personal Injury. More than two people are
recommended to lift the dryer into position because
of its weight and size. Failure to do so could result in
injury.
• Align the holes in the bracket with the holes in the back of the dryer.Using a Phillips
screwdriver, attach the M4x12 tapping screws.
• Tighten the washer bracket screws ; then tighten all stacking kit screws.
6.
Finalise the installation
• Refer to the washer Installation Instructions to
complete the washer installation.
• Refer to the dryer Installation Instructions to complete
the dryer installation.
• Carefully slide or walk the stacked washer and dryer
into place. Use felt pads or other sliding device to
assist moving and to protect flooring.
Do not push on the dryer once installed to top of the washer. Pushing on the dryer may
result in pinched fingers.
02 INST
ALLING YOUR DR
YER
Bracket-Stacking
WARNING
Screw
CAUTION
WARNING
Dryer
Washer
SDC1A809-02805J-05_EN_140507.indd Sec3:15
SDC1A809-02805J-05_EN_140507.indd Sec3:15
2014-05-07
6:29:45
2014-05-07
6:29:45