Samsung SCH-470, Service Manual, Page: 58 / 66

Test Command Table
9-2 Samsung Electronics
Command No.
(OP, AB, RB)
70(CA, 3, 0) T_WRITE_BATT_I
3)
Write battery level.
71(D1, 3, 0) T_CDMA_TXADJ_I
2)
Set tx_agc_adj in CDMA mode.
74(D4, 3, 0) T_TXADJ_OBM_I Set tx_agc_adj for 0 dBm power.
75(D5, 0, 3) T_READ_RSDI_I
3)
Read RSSI.
76(D6, 3, 0) T_WRITE_RSSI_I
3)
Writes RSSI.
77(D7, 0, 3) T_READ_REMP_I Read a temp.
79(D9, 1, 0) T_BUZZER_ON_I 2) Buzzer on.
80(DA, 0, 0) T_BUZZER_OFF_I Buzzer off.
81(E3, 0. 0) T_VOC_PCMLPON_I Play a PCM LOOP BACK.
82(E4, 0, 0) T_VOC_PCMLPOFF_I Play off a PCM LOOP BACK.
85(E7, 0, 0) T_SPEAKER_ON_I Turn on the speaker path.
86(E8, 0, 0) T_SPEAKER_OFF_I Turn off the speaker path.
89(EB, 3, 0) T_CDTRK_ADJ_I
3)
Set trk_lo_adj in CDMA mode.
90(F0, 4, 0) T_HW_CHANFLAT_T Measure the feature of the channel deviation.
(before adjusting)
91(F2, 4, 0) T_SW_CHANFLAT_T Check the feature of the channel deviation applied
channel deviation algorithm. (after adjusting)
93(F3, 4, 0) T_CH_FLATLESS_I Setting 22dBm channel deviation 10 Points.
Signal. Name
Description
1)
The AB (Input Argument Byte Number) values of these commands are used only in the manual test. In
automatic test mode, the AB is regarded as 0.
2)
You can assign the value for these commands. If the AB value is assigned without argument, the test is
achieved with the value stored in EEPROM.
3) After you get a desired test value by performing these commands, if you want to save the value into
EEPROM, use T-SAVE-VAL-I command to store the test value into the corresponding position.
¶S OP: Operation Command Number
AB: Input Argument Byte Number
RB: Return Byte Number