Adjustment
7-4
Copyright© 1995-2012 SAMSUNG. All rights reserved.
7-3 Shutter close time ADJ
■
Adjust the Close timing of the device shutter by camera.
■
Because there is a deviation of shutter closing time by each set, make adjustments by each set to reduce this deviation.
■
CCD Gain item and AWB LOW are adjusted simultaneously.
<Adjustment method>
1. Prepare the AE TESTER that can be adjusted to
LV 12
.
2. Install the camera to the AE TESTER.
* Luminance specification of the Light box is
LV 12
.
* The colour temperature specification of the Light box is
5500K
.
3. After inserting the memory card containing the program file to the camera, turn on the power of the camera.
4. The adjustment process will automatically start.
q
Refer to the specification (Illuminance) for testing.
-Line delay and Sub delay are adjusted so that the appropriate value can be identified to the specification illuminance.
w
If the result line delay wish within the min and max range, it is OK. If it is outside of the range, process as NG.
e
Refer to the EEPROM WRITE information and write the adjustment result to EEPROM.
r
Refer to the CARD WRITE INFORMATION to write the adjustment result to the data file.
5. When the adjustment is completed, the camera will automatically be turned off.
<Adjustment result>
On the memory card, open and check if a CSV file was generated from the adjustment.
<Restriction>
If the capacity of CSV file is more than 30KB, clear all of the previous data and then, record
Fig. 7-2
Light source box
Tripod
Light source box
Camera
