4_
safety information
• Never start up an appliance
showing any signs of
damage. If in doubt, consult
your dealer. The room where
the refrigerator will be sited
must be 1m³ in size for every
8g of R600a refrigerant
inside the appliance. The
amount of refrigerant in your
particular appliance is shown
on the identification plate
inside the appliance.
SEVERE WARNING
SIGNS FOR
INSTALLATION
• Do not install the
refrigerator in a damp
place or place where it
may come in contact
with water.
- Deteriorated insulation of
electrical parts may cause
an electric shock or fire.
• Do not place this refrigerator
in direct sunlight or expose
to the heat from stoves,
room heaters or other
appliance.
• Do not plug several
appliances into the same
WARNING
multiple power board.
The refrigerator should
always be plugged into its
own individual electrical
which has a voltage rating
that matched the rating
plate.
- This provides the best
performance and also
prevents overloading house
wiring circuits, which could
cause a fire hazard from
overheated wires.
• If the wall socket is loose, do
not insert the power plug.
- There is a risk of electric
shock of fire.
• Do not use a cord that
shows cracks or abrasion
damage along its length or
at either end.
• Do not bend the power cord
excessively or place heavy
articles on it.
• Do not use aerosols near the
refrigerator.
- Aerosols used near the
refrigerator may cause an
explosion or fire.
• This refrigerator must
be properly installed
and located in
Summary of Contents for RSH7 series
Page 30: ...30_ troubleshooting circuit diagram ...
Page 31: ...memo ...