5
DISASSEMBLING PARTS
Refrigerator shelf
Draw out it till the block, lift the shelf rear and pull
it out.
(position the shelf as per the container's height)
Fruit and vegetable tray and cover
Pull out the fruit and vegetable tray.
Drive up the cover head and put it out.
Freezer tray
Draw out it till the block, lift the shelf rear and pull
it out.
Egg guard and bottle guard
Lift them up to dismantle it.
The wire bar of the bottle guard may vary as per
requirement.
REPLACE OF BUILT-IN LIGHT
Pull out the plug
Turn off the screw in the lampshade back press the
center by fingers and push back to take out the
lampshade.
Turn off the bulb counterclockwise.
Screw on the bulb clockwise.
Hang on the hook under the cover and turn upward
to push into the upper hook.
Lamp parameter: 220V/240V, 15W
8
HOW TO USE
Cover
Moisture
control
slide
Fruit and
vegetable
tray
Partition
FRUIT AND VEGETABLE COMPARTMENT
You may adjust the moisture of the fruit and vegetable
compartment by the moisture control slide. The slide
towards the two sides may increase the moisture, vice
versa.
The partition of the fruit and vegetable tray separates
the fruit and vegetable compartment into two parts.
You are allowed to adjust it according to the fruit and
vegetable types and quantities to meet a satisfactory
need of storage space.
The fruit and vegetable compartment is able to preserve
the water content and freshness of the fruits and
vegetables as it is sealed to prevent cold air touching
the fruits and vegetables. It is appropriate to the storage
of vegetables and fruits.
Caution:
Tropical fruits, such as banana and pineapple are
not recommended.
The temperature is adjusted by the slide under the
control of temperature controller. The signs WARM ,
MID and COLD , on the knob receptively indicate
the inside temperature condition. Under the same
circumstance, stronger the knob reflects, lower the
inside temperature is. OFF means stopping working.
In normal use, adjust the slide at the MID and
change it to the location between WARM and MID
if any hot weather. If the room temperature is below
15
, then open the season switch and change the
slide to the location between MID and COLD .
If the room temperature is below 10
, it's a must to
locate the slide at the WINTER area.
MECHANICAL TEMPERATURE ADJUSTMENT
Season switch
Temperature adjustment
¹Ø
