04_
safety information
any naked flames or potential
sources of ignition and air the
room in which the appliance is
standing for several minutes.
• In order to avoid the creation
of a flammable gas-air mixture
if a leak in the refrigerating
circuit occurs, the size of the
room in which the appliance
may be sited depends on the
amount of refrigerant used.
• Never start up an appliance
showing any signs of damage.
If in doubt, consult your
dealer.
The room where the
refrigerator will be sited must
be 1 m³ in size for every 8 g
of R600a refrigerant inside the
appliance.
The amount of refrigerant in
your particular appliance is
shown on the identification
plate inside the appliance.
SEVERE WARNING
SIGNS FOR
INSTALLATION
• Do not install the
refrigerator in a damp
place or place where it
may come in contact
with water.
- Deteriorated insulation of
electrical parts may cause an
electric shock or fire.
• Do not place this refrigerator
in direct sunlight or expose to
the heat from stoves, room
heaters or other appliance.
• Do not plug several
appliances into the same
multiple power board.
The refrigerator should always
be plugged into its own
individual electrical which has
a voltage rating that matched
the rating plate.
- This provides the best
performance and also
prevents overloading house
wiring circuits, which could
cause a fire hazard from
overheated wires.
• If the wall socket is loose, do
not insert the power plug.
- There is a risk of electric
shock of fire.
• Do not use a cord that shows
WARNING
DA99-02116A (EN)-12.indd 04
DA99-02116A (EN)-12.indd 04
2014. 8. 14.
1:26
2014. 8. 14.
1:26