Samsung RF323TEDBSR, User Manual

Page: 7 / 84

setting up _07
01 SETTING
UP
When moving your refrigerator
To prevent fl oor damage, be sure the front
adjusting legs are in the up position (above
the fl oor). Refer to ‘Adjusting the Level’ in
the manual (on page 9).
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the fl oor. This surface
should be strong enough to support a fully loaded
refrigerator, or approximately 359lbs (165kg).
To protect the fi nish of the fl ooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working. When
moving the refrigerator, you need to pull and push
it straight forwards or back. Do not wiggle it from
side to side.
ACCESSORIES AND
REQUIRED TOOLS
The following accessories are included with your
refrigerator:
Hex wrench Fastener
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips
screw)
Flat-blade screw
driver(-)
Socket wrench
(10mm)
Pliers
Allen wrench
(3/16”) (5mm)
REMOVING THE
REFRIGERATOR DOORS
For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its fi nal location.
Do not remove
the doors/drawer if you don’t need to. If you
do not need to remove the refrigerator doors, go
to Adjusting the Level on page 9. If you need to
remove the doors. continue below.
Before removing the door/drawer, make sure you
read the following items:
Disconnect power to the refrigerator before
removing the door or drawer.
Be careful not to drop, damage, or •
scratch the door/drawer while removing
them.
Use care when you remove the doors/drawer. •
The doors are heavy and you could injure
yourself.
Reattach the doors/drawer properly to avoid:
•
Moisture from air leakage. -
Uneven door alignment. -
Wasting energy due to improper door seal. -
Disassemble the refrigerator doors
Be careful not to drop and scratch the
doors while removing them.
CAUTION
Flat-blade screw Flat-blade screw
driver(-)
driver(-)
Control Lever Control Lever
WARNING
WARNING
DA68-02603A.indb 07 DA68-02603A.indb 07 2012.5.30 1:25:7 PM 2012.5.30 1:25:7 PM