English - 16
Snap Rings included with the refrigerator:
1 mm
1.5 mm
2 mm
2.5 mm
HOW TO ADJUST THE DOOR GAP
If the gap between the left and right fridge
compartment doors is not even.
• You can adjust the gap by
turning the bolt at the top
right of the cold storage
compartment door.
• Do not turn the bolt too far.
You can break it.
1. With the doors closed, remove the 3 screws
holding the top cover using a Phillips
screwdriver, and then lift it off together with the
connected cables.
2. Turn the bolt with a 4 mm
hexagonal L-wrench to
adjust the gap.
3. Turn the bolt clockwise to (
) widen the
gap. Turn the bolt counterclockwise (
) to
narrow the gap.
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator.
To help promote better health, the water filter
removes unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms.
You may need to purchase a water purifying
system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20 ~ 125 psi is required.
If the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator is
properly filled.
To do this, press the water dispenser lever until the
water runs from the water outlet.
• Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and a 6 mm (¼”) compression nut.
• Use the new hose-sets supplied with the
appliance only. Do not re-use an old hose set.
Connecting to the water supply line
1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Pipe clamp
Cold water line
Shut off valve
DA68-03194D-06.indb 16
2018. 7. 9.
4:40
