ENGLISH-
24
troubleshooting
Symptom
checklist
the PoWERbot is not
working at all.
f
Check if the emergency switch is on.
f
Check if all the icons are displayed on the display panel.
f
Check if the POWERbot's battery is depleted.
-
When "Lo" is displayed, carry POWERbot to the docking station to charge it.
f
Replace the batteries (AAA type) if the remote controller is not working.
the PoWERbot
has stopped during
cleaning.
f
When "Lo" is displayed on the display panel, carry POWERbot to the docking
station to charge it.
f
When POWERbot is immobilized by an obstacle such as a cord, threshold etc,
pick it up and move it away from the obstacle.
-
If any fabric or string is caught in a drive wheel, turn off the emergency switch
and remove the fabric or string before using it again.
Suction power is weak.
f
If the "Filter inspection indicator" is on, turn off the emergency switch and clean
the dustbin.
f
When there's too much dust in the dustbin, suction power may get weakened.
Turn off the emergency switch and empty the dustbin.
f
If the intake (on bottom of POWERbot) is blocked by foreign matter, turn off the
emergency switch and remove foreign matter from the intake.
f
When noise suddenly increase, turn off the emergency switch and empty the
dustbin.
the PoWERbot cannot
find the docking
station.
f
Check if there's a power failure or whether the power plug is unplugged.
f
Remove any obstacles around the docking station that may prevent
POWERbot from returning to the docking station.
f
When there's foreign matter on the charge pins, charging can be affected.
Clean the foreign matter off the pins.
the PoWERbot
suddenly cleans
diagonally.
f
Check if the docking station is installed along the grain of wooden floors or
tiles.
f
The POWERbot may clean in a diagonal direction if it is moving to another area
using the shortest route. It may also move at a diagonal if it made contact with
an obstacles at that angle, if it was charged at the charger at an angle, or if the
grain of the wooden/tile floor skewed is in that direction.
Point cleaning is not
working.
f
If you point the red light directly at POWERbot, it may not move in desired
direction.
-
Point the red light on the floor within 50 cm of POWERbot.
✻
✻
Do not use point cleaning in direct sunlight, under bright light, or on dark floors.
"Filter inspection
indicator" is on even
after the dustbin has
been emptied.
f
Turn off the emergency switch and then turn it back on.
f
Empty the dustbin again and re-clean the filter thoroughly.
1_SR20H9050U#AA-EN_00716Q-06_USA.indd 24
2015-08-07 오후 4:51:58
