Samsung PN15VT / VO, Service Manual

Page: 8 / 82

3-1-1 Before making Disassembly
1. Disconnect the power cord from the monitor.
2. With a pad beneath it, stand the monitor on its
front with the screen facing downward and
the base close to you.
3-1-2 Cabinet Disassembly
1. Remove the Stand from the monitor.
(Refer to Stand manual)
2. Incline the monitor by lifting the rear of the
monitor.
3. Push the Opening jig each groove along the
top of the monitor till it makes a “ttak” sound.
(2 grooves : Left and Right, Make sure each
snap is disengaged.)
4. Remove 2 screws on the Rear cover.
5. Pull the Rear Cover up off the monitor.
6. Remove the Shield.(TCO 99)
6. Using pinch-nose pliers or ling-nose pliers,
acrefully disconnect the Anode Cap from the
CRT.
Warning: Do not touch the Anode contact
on the CRT (High Voltage may
remain).
PN15VT/VO
PN15HT/HO 3-1
3 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
PN15VT/VO/HT/HO monitors.
WARNING: This monitor contains electrostatically sensitive devices. Use with caution when
handling these components.
3-1 Disassembly
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. To remove the Rear Cover, you must use the special opening jig tool.
Figure 1
Figure 2
Figure 3