Samsung PDP4294X/SMS, Service Manual

Page: 11 / 104

Alignment and Adjustments
Samsung Electronics 2-9
Alignment and Adjustments
2-2 WHITE Balance Coordinates
2-2-1 SPN4235 White Balance Adjustment
1. W/B Adjustment is required for the following four modes: DVI
→
DTV
→
PC
→
RF
2. Adjustment Method (DVI, DTV, PC : VG828, RF : Adjust RF signals to match the
Toshiba pattern (in-house signal)
!
Adjust the target set by adjusting the panel logic and the video DNIe adjustment register in
register in order to determine the referential W/B of the panel with a DVI input, which
is the full digital path.
@
For DTV adjustment, adjust the adjustment register of AD9883 to align the DTV signal
to the DNIe and logic panel value which was fixed with a DVI adjustment so that they are
in effect considered to be the same signals. (At this time, do not adjust the gain of
AD9883
→
the Highlight W/B does not need to be adjusted since its deviation falls
within valid distribution range.)
#
PC adjustment is same as DTV adjustment. (The offset can be applied to the values
obtained through DTV adjustment. However, additional adjustment is required for
Y, Cb, and Cr of DTV since PC processes R, G, and B signals.)
$
RF adjustment is performed with the Toshiba pattern (in-house signal) and differs
from the VG828 signals in the above three modes. Hence, it should be performed with
the same method of
!
DVI adjustment.
❈
Thus, Micom saves the W/B data separately for each memory mode of the block
(See the block diagram given below) during W/B adjustment.
Adjustment Reg
Adjustment Reg
Adjustment Reg
Memory mode
Memory mode
Memory mode
level
level
Micom can memorize the four modes
separately. However, under the current
adjustment guidelines, DTV and PC are
memorized with the same value during
DVI adjustment and RF is memorized
with a separate value.