Samsung NX58M9420SS Series, Installation Manual

Page: 16 / 84

16 English
Ins
tallation r
equir
ement
s
Installation requirements
Optional rear filler kit
WARNING
Used to fill gap between the range back and wall. Adds a filler strip to the rear of
the range. This kit can only be used when the opening in the countertop is 25” deep.
NOTE
If the countertop depth is greater than 25”, there will be a gap between the filler
kit and the back wall.
To avoid breakage
CAUTION
Please DO NOT push the unit strongly when
you install. These actions can cause the
damage to the unit.
Please DO NOT push the burner knobs when
installing the range.
(Grasp the L/R door area to push the unit.)
CAUTION
Do NOT lift or handle the unit by the cooktop frame.
Fig. 1
C1
C2
C3
C4
1. The counter top around the cut-out
should be flat and leveled (See hatched
area on Fig. 1).
2. Before installing the unit, measure the
heights of the two cabinet sides (C1~C4),
front and back (See Fig. 1) from the floor
to the top of the counter.
3. Level the range using the four leveling
legs so that the height from the floor
to the underside of the cooktop frame
is greater than the tallest cabinet
measurement
by at least
1
/
16
” .
4. Slide the unit into the cabinet ( DO NOT
PUSH THE UNIT HARD ). Make sure the
center of the unit aligns with the center
of the cabinet cut-out.
5. The metal flange under each side of the
cooktop
MUST be placed over the cabinet
countertop for proper unit support. The
cooktop should
NOT
rest directly on the
countertop or else it could cause damage
to the cooktop voiding the warranty.
Level the unit if needed.
IMPORTANT:
MAKE SURE the unit is supported by the
leveling legs and NOT by the cooktop itself.
Install_NX58M9420SS_DG68-00906A-00_EN.indd 16 1/6/2017 6:25:50 PM