14
Installing DPM
▶
When installing DPM, you should set ‘DPM setting’ to the outdoor unit.
▶
If DPM model is not set, communication error may occur.
▶
While the outdoor unit is tracking the indoor unit for one minute after the power supply is turned on, the operation may
stop if the remote control reception signal of the installed indoor unit is different.
Drainpipe and drain hose installation
You should test the drainage after completing the installation.
Prepare a little water about 2.0 liters.
1 Turn the cover drain pump, then pull it out.
2 Pour water into the indoor unit as shown in figure.
3 Confirm that the water flows out through the drain hose.
4 Reassemble the cover drain pump.
Testing the drainage
• If you do not pour water inside the water supply intake, water may
spill from the indoor unit.
• You can check the drainage only when the air conditioner is in cool
mode.
Water leakage
check part
Hose
ND＊＊＊4HXEA_IM_E_33497A(1).indd 14
2011-03-08 오후 2:00:23
