Samsung MH020FVEA, Service Manual

Page: 52 / 172

Alignment and Adjustments
3-13 Samsung Electronics
7
8
Press button, then the default value is .
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
10
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
9
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
11
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
12
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
11
9 8
7 10
12
✳
Setting is not required if you must
a value which has a default.
Step 3 : Upon completion of the selection, check you made right selections.
Press the Mode Selection key, to set the display part to and check the display part.
The display part shows .
Press the Mode Selection key, to set the display part to and check the display part.
The display part shows .
Step 4 : Pressing the ON/OFF button ( )
When pressing the operation ON/OFF key with the direction of remote control for unit, the sound ''Ding'' or ''Diriring''
is heard and the OPERATION ICON( ) lamp of the display is flickering at the same time, then the input of option is
completed. (If the diriring sound isn't heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run
First, Remove the battery from the remote control.
Second, Re-insert the battery into the remote control.
Third, Press ON/OFF key with the direction of remote control for set.
• Error Mode
1 st If all lamps of indoor unit are flickering, plug out, plug in power plug again and press the ON/OFF key to retry.
2 nd If the unit is not working properly or all lamps are continuously flickering after setting the option code, see if the correct option code
is set up for its model.