13
Step-by-step installation guide
3
. Remove the screw that holds the blower motor
and carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust the
blower unit.
blower mortor screw
CAUTION
: To avoid breaking or cracking the blower
blade, do not touch the blade. Hold the outer case
of the blower when you pull it out or put it back in
place.
4
. Roll the blower unit 90 ° so that the fan blade
openings are facing toward the front of the
microwave.
Back of
Microwave
Before Roll
After Roll
Back of
Microwave
5
. Place the blower unit back into the opening.
CAUTION
: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
6
. Secure the blower unit to the microwave with the
screw.
B2. INSTALLING THE CHARCOAL
FILTER
1
. Remove the screws on the top of the grille using
a #1 Phillips screwdriver.
2
. Open the door.
3
. Remove the grille.
• Push the grille left, and then pull the grille straight
off.
Charcoal filter
4
. Install the charocal filter. When properly installed,
the wire mesh of the filter should be visible from
the front.
5
. Reinstall the grille and the screws.
6
. Close the door.
Insert mesh-side up
ME16H702SEB_AA_DE68-00000A-00_EN.indd 13
2019-03-06 4:25:20
