19
Step-by-step installation guide
To use toggle bolts:
Wall
Toggle Wings
Toggle
Bolt
Bolt End
Spacing for Toggles More
Than Wall Thickness
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
Bolt End
Mounting
Plate
Toggle
Bolt
Wall
Toggle Wings
3
. Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE
: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the wall
and that the plate is properly centered under the cabinet.
CAUTION
: Be careful to avoid pinching your fingers
between the back of the mounting plate and the wall.
4
. Tighten all bolts. Pull the plate away from the wall to
help tighten the bolts.
C3. USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws, a hole
large enough for the power cord to fit through, and a
cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION
: Wear safety goggles when drilling holes in
the cabinet bottom.
C4. ADAPTING MICROWAVE BLOWER FOR
OUTSIDE BACK EXHAUST
1
. Remove and save screws that hold the blower plate
and the blower motor to the microwave.
Back of
Microwave Oven
Blower
Retaining
Screws
2
. Open the blower door by lifting it up at the back
of the microwave. Remove and save the blower
shield on the back of the microwave by sliding it up.
Remove and save the metal vent fan cover on the
back of the microwave by sliding it up.
3
. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the blower
unit.
BEFORE: Fan Blade
Openings Facing Forward
End B
End A
4
. Remove Parts “A” with tin snips or pliers.
(On Some Model)
Parts “A”
OTR_II_DE68-03587B-07_EN+CFR.indb 19
OTR_II_DE68-03587B-07_EN+CFR.indb 19
2022-01-20 �� 10:11:55
2022-01-20 �� 10:11:55
