16
Step-by-step installation guide
B3. ADAPTING MICROWAVE BLOWER FOR
RECIRCULATION
1
. Remove and save screw that holds blower plate to
microwave.
2
. Lift up the blower plate.
Back of
Microwave Oven
Blower
Retaining
Screws
NOTE
: The exhaust adaptor with damper is not needed
for recirculating models. You may want to save them for
possible future use.
3
. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the blower
unit.
CAUTION
: Do not touch blade of blower forpreventing
crack and break. Hold outer case when the blower pull
out or back into.
4
. Roll the blower unit 90° so that fan blade openings
are facing toward the front of the microwave.
Before Roll
After Roll
5
. Place the blower unit back into the opening.
CAUTION
: Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched.
6
. Remove the metal vent fan cover on the back of the
microwave by sliding it up.
7
. Close the blower door. Slide blower shield onto the
top of the blower door opening.
8
. Secure the blower to the microwave using the blower
retaining screws from Step 1.
Back of
Microwave Oven
Blower Retaining
Screws
Blower Retaining
Screw
B4. MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT: Do not grip or use the handle during
installation.
NOTE
: If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the cord.
NOTE
: We recommend using filler blocks if the cabinet
front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from over tightening screws.
OTR_II_DE68-03587B-07_EN+CFR.indb 16
OTR_II_DE68-03587B-07_EN+CFR.indb 16
2022-01-20 �� 10:11:55
2022-01-20 �� 10:11:55
