GB
9
Insert or replace remote control batteries when you:
Purchase the mini-compact system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and
never mix alkaline and manganese batteries.
Place your thumb on the position marked on the battery com-
partment cover (rear of the remote control) and push the cover in the
direction of the arrow.
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
+ on the battery a on the remote control
–
on the battery against - on the remote control
Replace the cover by sliding it back until it clicks into position.
All functions available on the system can be viewed on the
display and the display's brightness can be switched between
"on" and "off".
Press the Demo/Dimmer button.
Result: All functions available on the system appear on the front
panel display.
Each of these are explained in detail in this guide. Please refer to
the relevant section.
Press the Demo/Dimmer button again.
Result: The Dimmer function is selected and the display darkens.
Press the Demo/Dimmer button once again to brighten the front
panel display.
A display brightness control can only be performed while the
system power is on.
Your system is equipped with a clock which allows you to
turn your system on and off automatically. You should set the
clock:
When you purchase the mini-compact system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing Standby/on.
Press Timer/Clock twice.
Result:
CLOCK
is displayed.
Press Enter.
Result: The hour flashes.
To...
Press the...
Increase the hours
Tuning Up
Decrease the hours
Tuning Down
When the correct hour is displayed, press Enter.
Result: The minutes flash.
To...
Press the...
Increase the minutes
Tuning Up
Decrease the minutes
Tuning Down
When the correct time is displayed, press Enter.
Result: The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another
function, by pressing
Timer/Clock
once.
You can also use
Program/Set
button on the remote control
to instead
Enter
button in step 3,5,7.
Setting the Clock
Demo/Dimmer function
2
1
1
2
3
4
5
6
7
Inserting Remote Control Batteries
1
2
3
1
4,6
3
3,5,7
2
4,6
MAX-ZB450 GB R-1~16 5/9/03 11:41 Page 9
