Samsung MAX-A65, User Manual

Page: 4 / 13

ENG
7
To take full advantage of your new mini-compact system, follow
these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
Maintain an open space of approximately 6 inches (15 cm) on the
sides and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc
compartment easily.
Place the loudspeakers at a reasonable distance on either side of
the system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed
at an equal distance above the floor.
Where to Install Your Mini-Com-
pact System
Connecting your System to the
Power Supply
ENG
6
Insert or replace remote control batteries when you:
Purchase the mini-compact system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and
never mix alkaline and manganese batteries.
Place your thumb on the position marked on the battery
compartment cover (rear of the remote control) and pull the cover in
the direction of the arrow.
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
+ on the battery a in the battery compartment
– on the battery against – in the battery compartment
Replace the cover by sliding it back until it clicks into position.
If you will not be using the remote control for a long time,
remove the batteries to prevent corrosion.
Inserting Remote Control Batteries
1
2
3
VOLUME
STANDBY/ON
TUNER MP3-CD/CD USB AUX
Connecting Audio from External
Components
Before plugging your system into a main socket, you must check
the voltage.
Plug the main lead into an appropriate socket.
Press the (STANDBY/ON) button to switch your mini-compact
system .
1
2
The loudspeaker connector terminals are located on the rear
of the system.
There are four terminals on the system:
left speaker (marked L)
FRONT -H (high sound)
FRONT -L (low sound)
right speaker (marked R)
FRONT -H (high sound)
FRONT -L (low sound)
To achieve the correct sound quality,insert those speaker con-
nector cables to the speaker connector terminals of the sys-
tem.
Make sure the colors of the speaker terminals match the col-
ors of the connecting plugs.
Connecting the Loudspeakers
How to connect a COAXIAL TYPE aerial.
Connect a 75
Ω
antenna to the FM antenna terminal.
Plug the connector on the FM aerial supplied into the coaxial socket
(75
Ω
) marked FM on the rear of the system.
Follow the instructions given on Page 15 to tune into a radio station,
and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor
FM aerial to the FM socket on the rear of
the system using a 75
Ω
coaxial cable (not supplied).
Connecting the FM Aerial
FRONT -H FRONT -H
FRONT -L FRONT -L
2.0CH SPEAKERS OUT
ANTENNA
AUX IN 2
IMPEDANCE FRONT:4
R L
R L
FM (75 )
L
R
FRONT -H FRONT -H
FRONT -L FRONT -L
2.0CH SPEAKERS OUT
ANTENNA
AUX IN 2
IMPEDANCE
FRONT:4
R L
R L
FM (75 )
L
R
FRONT -H FRONT -H
FRONT -L FRONT -L
2.0CH SPEAKERS OUT
ANTENNA
AUX IN 2
IMPEDANCE FRONT:4
R L
R L
FM (75 )
L
R
FRONT -H FRONT -H
FRONT -L FRONT -L SUBWOOFER
2.1CH SPEAKERS OUT
IMPEDANCE FRONT:4 SUBWOOFER:3
R L
R L
L R
SW
MAX-A66
FRONT -H FRONT -H
FRONT -L FRONT -L
2.0CH SPEAKERS OUT
IMPEDANCE FRONT:4
R L
R L
L
R
MAX-A65
VOLUME
AUX IN 1 MIC1 MIC2 MIC VOL ECHO
STANDBY/ON
TUNER MP3-CD/CD USB AUX
AUX1 : Front Panel
Audio Cable
(not supplied)
AUX1 : Connecting an External Component/MP3 player
Components such as an MP3 Player
1
Connect AUX IN 1 (Audio) on the MINI COMPACT front panel to the
Audio Out of the external component/MP3 player.
2
Press the AUX button to select <AUX1> input.
The mode switches as follows : AUX 1
➝
AUX 2.
FRONT -H FRONT -H
FRONT -L FRONT -L
2.0CH SPEAKERS OUT
ANTENNA
AUX IN 2
IMPEDANCE
FRONT:4
R L
R L
FM (75 )
L
R
AUX2 : Rear Panel
Audio Cable
(not supplied)
If the external analog
component has only
one Audio Out, con-
nect either left or right.
AUX2 : Connecting an External Analog Component
Analog signal components such as a VCR.
1
Connect AUX IN 2 (Audio) on the MINI COMPACT rear panel to the Audio
Out of the external analog component.
■
Be sure to match connector colors.
2
Press the AUX button to select <AUX2> input.
The mode switches as follows : AUX 1 ➝ AUX 2.