Samsung MAX-810, Service Manual

Page: 13 / 72

Samsung Electronics 3-5
Disassembly and Reassembly
3-5 CD Mecha Continued
3-5-1 Tray Disassembly
3-5-2 Main Disassembly
3-5-3 CD Main PCB Disassembly
*When removing, take extreme care not to damage the hook.
1. Open the Tray Disc AssÕy by turning the Gear-Load(
%
) in the direction of open,then remove the Wire-Tray(
Q
).
2. Remove two Tray-Stopper and tray.
1. Remove the Tray-Roulette(
3
) from the Tray-Disc AssÕy(
4
) by releasing the hook.
2. Remove the PCB-Sensor AssÕy(
5
) from the tray by releasing the hook.
3. Remove the Worm-Motor AssÕy(
)
)from the Tray-Disc AssÕy(
4
).
4. Remove the Cushion-Motor(
1
) from the Tray.
5. Remove the Gear-Roulette(
2
) from the Tray-Disc AssÕy(
4
) by releasing the hook.
1. Remove the Table-Chuck AssÕy(
6
) from the Base-Main by turning it.
2. Push the Slider-Cam(
!
)towards right, then lift it up to remove.
3. Remove the Gear-Tray(
^
) from the Base-Main by releasing the fixed hook.
4. Remove the Gear-Converter(
&
)from the Base-Main by releasing the fixed hook.
5. Remove the Gear-Cam(
%
) from the Base-Main by releasing the fixed hook.
6. Remove the Belt(
@
) from the Pulley-Motor AssÕy(
7
) & the Gear-Pulley(
#
).
7. Remove the Gear-Pulley(
#
) from the Base-Main by releasing the fixed hook.
8. Remove the Gear-Load(
$
).
9. Remove the Gear-Synchro(
*
).
10. Desolder two soldering points of the CD SUB PCB, then remove it from Base-Main by
releasing the hook.
11. Remove the Pulley-Motor AssÕy(
7
) by releasing the hook.
12. Remove the PCB-SW AssÕy(
8
) by releasing the hook.
1. Remove the Lever-Lifter(
9
) from the Base-Main by releasing two hooks.
2. Remove four Rubber-CD(
0
) from the Lever-Lifter and then remove the Deck-CD(
“
).
3. Remove the Hook.
4. Remove the CD MAIN PCB with the soldering iron.