7) Select MAC address at
“Board list”
.
8) Enter IP Address, Subnet mask, Default Gateway according to your Sub environment.
- Caution:
There is no Gateway when the printer is connected to PC direct. Write the
Same with IP address at Gateway address.
- Notice:
Ethernet interface requests Gateway device to save its own IP address when
Data transmission does not take place for more than 5 minutes
9) Enter value at Local port.
(Default:
6000,
choose from 6000 to 10000)
10) Set Baud rate.
(Set it as same as the printer condition. Highest bps can be used)
11) When setting finishes select
“Setting”
.
12) Select
“Exit”
and finish the program.
NOTE 1.
“DHCP mode” is for
DHCP server.
(DHCP: Dynamic Host Configuration Protocol)
NOTE 2. “Upload” button is used to upgrade Firmware.
V3.0.0
www.samsungminiprinters.com
5
