Samsung iES4028F, Management Manual

Page: 673 / 712

Multicast Filtering Commands
4-337
4
Command Mode
IGMP Profile Configuration
Command Usage
Enter this command multiple times to specify more than one multicast address
or address range for a profile.
Example
ip igmp filter (Interface Configuration)
This command assigns an IGMP filtering profile to an interface on the switch. Use
the
no form to remove a profile from an interface.
Syntax
[ no ] ip igmp filter profile-number
profile-number - An IGMP filter profile number. (Range: 1-4294967295)
Default Setting
None
Command Mode
Interface Configuration
Command Usage
• The IGMP filtering profile must first be created with the ip igmp profile
command before being able to assign it to an interface.
• Only one profile can be assigned to an interface.
• A profile can also be assigned to a trunk interface. When ports are configured
as trunk members, the trunk uses the filtering profile assigned to the first port
member in the trunk.
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#range 239.1.1.1
Console(config-igmp-profile)#range 239.2.3.1 239.2.3.100
Console(config-igmp-profile)#
Console(config)#interface ethernet 1/1
Console(config-if)#ip igmp filter 19
Console(config-if)#