Samsung iES4028F, Management Manual

Page: 605 / 712

VLAN Commands
4-269
4
Command Mode
Global Configuration
Command Usage
• A port cannot be configured in both an uplink and downlink list.
• A port can only be assigned to one traffic-segmentation session.
• A downlink port can only communicate with an uplink port in the same
session. Therefore, if an uplink port is not configured for a session, the
assigned downlink ports will not be able to communicate with any other ports.
• If a downlink port is not configured for the session, the assigned uplink ports
will operate as normal ports.
• Due to switch ASIC limitations, ports 1-8, 9-16, 17-24 are grouped together
when any group member is configured as an uplink or downlink interface.
Example
pvlan session
This command creates a traffic-segmentation client session. Use the no form to
remove a client session.
Syntax
[ no ] pvlan session session-id
session-id – Traffic segmentation session. (Range: 1-15)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use this command to create a new traffic-segmentation client session.
• Using the
no form of this command will remove any assigned uplink or
downlink ports, restoring these interfaces to normal operating mode.
Example
Console(config)#pvlan session 1 uplink ethernet 1/5 downlink ethernet 1/6
Console(config)#
Console(config)#pvlan session 1
Console(config)#