Samsung iES4028F, Management Manual

Page: 584 / 712

Command Line Interface
4-248
4
show spanning-tree mst configuration
This command shows the configuration of the multiple spanning tree.
Command Mode
Privileged Exec
Example
VLAN Commands
A VLAN is a group of ports that can be located anywhere in the network, but
communicate as though they belong to the same physical segment. This section
describes commands used to create VLAN groups, add port members, specify how
VLAN tagging is used, and enable automatic VLAN registration for the selected
interface.
Console#show spanning-tree mst configuration
Mstp Configuration Information
--------------------------------------------------------------
Configuration name: R&D
Revision level:0
Instance Vlans
--------------------------------------------------------------
0 1,3-4094
1 2
Console#
Table 4-68 VLANs
Command Groups Function Page
GVRP and Bridge Extension Configures GVRP settings that permit automatic VLAN learning;
shows the configuration for bridge extension MIB
4-249
Editing VLAN Groups Sets up VLAN groups, including name, VID and state 4-254
Configuring VLAN
Interfaces
Configures VLAN interface parameters, including ingress and egress
tagging mode, ingress filtering, PVID, and GVRP
4-256
Displaying VLAN
Information
Displays VLAN groups, status, port members, and MAC addresses 4-262
Configuring 802.1Q
Tunneling
Configures 802.1Q Tunneling (QinQ Tunneling) 4-263
Configuring Port-based
Traffic Segmentation
Configures traffic segmentation for different client sessions based on
specified downlink and uplink ports
4-267
Configuring Private VLANs Configures private VLANs, including uplink and downlink ports 4-271
Configuring Protocol VLANs Configures protocol-based VLANs based on frame type and protocol 4-276
Configuring Voice VLANs
Configures VoIP traffic detection and enables a Voice VLAN 4-279