Samsung iES4028F, Management Manual

Page: 566 / 712

Command Line Interface
4-230
4
Command Mode
Global Configuration
Command Usage
This command sets the time interval (in seconds) at which the root device
transmits a configuration message.
Example
Related Commands
spanning-tree forward-time (4-229)
spanning-tree max-age (4-230)
spanning-tree max-age
This command configures the spanning tree bridge maximum age globally for this
switch. Use the
no form to restore the default.
Syntax
spanning-tree max-age seconds
no spanning-tree max-age
seconds - Time in seconds. (Range: 6-40 seconds)
The minimum value is the higher of 6 or [2 x (hello-time + 1)].
The maximum value is the lower of 40 or [2 x (forward-time - 1)].
Default Setting
20 seconds
Command Mode
Global Configuration
Command Usage
This command sets the maximum time (in seconds) a device can wait without
receiving a configuration message before attempting to reconfigure. All device
ports (except for designated ports) should receive configuration messages at
regular intervals. Any port that ages out STA information (provided in the last
configuration message) becomes the designated port for the attached LAN. If
it is a root port, a new root port is selected from among the device ports
attached to the network.
Example
Console(config)#spanning-tree hello-time 5
Console(config)#
Console(config)#spanning-tree max-age 40
Console(config)#