Samsung iES4028F, Management Manual

Page: 416 / 712

Command Line Interface
4-80
4
Debug Commands
debug dot1x
This command configures debug settings for IEEE 802.1X authentication processes.
Use the
no form to disable debug mode for IEEE 802.1X.
Syntax
[ no ] debug dot1x
[ all | config | database | event | packet ]
[ show { all | state-machine [ pae | backend ]}]
• all - Sets debugging for all options (config, database, event, packet).
• config - Sets debugging for dot1x configuration settings.
• database - Sets debugging for dot1x database operations.
• event - Sets debugging for dot1x events.
• packet - Sets debugging for dot1x packets.
• show - Displays information about the specified debug type.
- all - Displays information for all options.
- state-machine - Displays information on state-machine events.
- backend - Displays information for backend state-machine events.
- pae - Displays information for authenticator state-machine events.
Default Setting
Disabled
Command Mode
Privileged Exec
Command Usage
• Use the debug dot1x command without any classification or feature to enable
debugging for all 802.1X authentication processes.
• Use the debug dot1x all command to enable debugging for all of the
classification options (i.e., config, database, event and packet).
• Use the debug dot1x classification show feature command to enable
debugging for the specified classification and feature. When debugging is
enabled for the
config classification, debug messages will be shown when
802.1X configuration commands are entered. When debugging is enabled for
the
database classification, debug messages will be shown when a memory
operation is applied to the 802.1X authentication database. When debugging
is enabled for the
event classification, debug messages will be shown when
Table 4-22 Debug Commands
Command Function Mode Page
debug dot1x Configures debug settings for IEEE 802.1X PE 4-80
debug radius Configures debug settings for RADIUS PE 4-82
debug tacacs Configures debug settings for TACACS PE 4-84