ENG -
14
• The maximum transmission distance of the main unit’s wireless signal is about 32.8 ft (10 m), but may vary depending on your operating
environment. If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all
because the wireless signal cannot penetrate metal.
CAUTION
• Wireless receiving antennas are built into the wireless subwoofer. Keep the unit away from water and moisture.
• For optimal listening performance, make sure that the area around the wireless subwoofer and the Wireless Receiver Module is clear of any
obstructions.
Connecting an SWA-9100 to your Soundbar
Expand to true wireless surround sound by connecting the Samsung Wireless Surround Speaker SET (SWA-9100) to your Soundbar.
1. Connect the Wireless Receiver Module to 2 Surround Speakers
Use the speaker cables to connect the two surround sound speakers to the Wireless Receiver Module.
• The speaker cables are color coded.
SURROUND-LEFT
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
L
R
SURROUND SPEAKERS OUT
SURROUND-RIGHT
SURROUND-LEFT
SURROUND-RIGHT
When connecting the speaker cables to the Wireless Receiver Module, follow these steps:
1.
Insert the grey plug into the grey jack on the Wireless Receiver.
2.
Insert the blue plug into the blue jack on the Wireless Receiver.
When connecting the speaker cables to the surround speakers, follow these steps:
1.
Match the speaker cable connected to the grey jack to the speaker with the grey label.
2.
Match the speaker cable connected to the blue jack to the speaker with the blue label.
3.
Insert the red and black colored ends of each speaker cable into the red and black jacks of the appropriate speaker.
• The labels are on the backs of the speakers.
2. Check the standby status after plugging into an electrical outlet
The LINK LED indicator (blue LED) on the Wireless Receiver Module blinks. If the LED does not blink, press the
ID SET
button on the back of the
Wireless Receiver Module with a pen tip for 5~6 seconds until the LINK LED indicator blinks (in Blue).
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
POWER
ID SET
STANDBY
LINK
LINK
5 Sec
Blue blinking
3. Configure “ID SET” using the Soundbar’s remote control
Turn off the Soundbar main. Press the
Up
button on the remote control for 5 seconds.
• The
ID SET
message appears on the display of the Soundbar for a moment, and then it disappears.
• The Soundbar will automatically power on when
ID SET
is complete.
OU
ND
E
PAIR
5 Sec
ID SET
