ENG - 15
LED Indicator Lights on the Rear of Wireless Surround speaker
LED status
Action
LINK (Blue)
On
Connected with the
Soundbar
-
Blinking fast
Pairing mode
Check if the Soundbar is turned on
Repeat steps 2 through 3.
Blinking slowly
Disconnected
ID SET
to change mode to Pairing mode.
STANDBY
(Red)
On
Connection failure
Check if the Soundbar is turned on
1.
Press the
ID SET
button on the back of the
Wireless Receiver Module with a pen tip for
5~6 seconds until the LINK LED indicator
blinks (in Blue).
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
POWER
ID SET
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
5 Sec
2.
Repeat steps 2 through 3.
Others
-
Errors
Contact a Samsung Service Center.
NOTES
•
Do not connect the power cord of this product or your TV to a wall outlet until all connections
between components are complete.
•
Before moving or installing this product, be sure to turn off the power and disconnect the power cord.
•
If the main unit is powered off, the Wireless Surround speaker will go into stand-by mode and the
STANDBY LED on the rear of the Wireless Receiver Module will turn red after blinking blue several
times.
•
If you use a device that uses the same frequency (5.8GHz) as the Soundbar near the Soundbar,
interference may cause some sound interruption.
•
The maximum transmission distance of the main unit’s wireless signal is about 32.8 ft (10 m), but
may vary depending on your operating environment. If a steel-concrete or metallic wall is between
the main unit and the Wireless Surround speaker, the system may not operate at all because the
wireless signal cannot penetrate metal.
PRECAUTIONS
•
Wireless receiving antennas are built into the Wireless Surround speaker. Keep the unit away from
water and moisture.
•
For optimal listening performance, make sure that the area around the Wireless Surround speaker
and the Wireless Receiver Module is clear of any obstructions.
