|
16
English
Connections
HD
SPEAKERS OUT
CENTER
SUBWOOFER
FRONT
L
FRONT
R
L
IMPEDANCE : 3
AUX IN
FM ANT
OPTICAL
DIGITAL
AUDIO IN
L
R
SPEAKERS OUT
CENTER
SUBWOOFER
FRONT
L
FRONT
R
IMPEDANCE : 3
Surround
Speaker (L)
Surround
Speaker (R)
Subwoofer
Centre Speaker
Front Speaker (R)
Front Speaker (L)
Wireless Receiver Module
* This product should be connected with the SWA-6000 only.
| CAUTION |
If you want to install the product on the wall, fasten the screws or nails on the wall firmly and use the holes on the
rear of speaker to install. However, when you install it, accessories (nails or screws) and installation is not provided by
the company.
Do not let children play with or near the speakers. They could get hurt if a speaker falls.
When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.
Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands or alien
substances into the duct (hole) of the subwoofer speaker.
Do not hang the subwoofer on the wall using the duct (hole).
The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture.
For optimal listening performance, make sure that the area around the wireless receiver module location is clear of
any obstructions.
If you hear no sound from the wireless surround speakers, switch the mode to Dolby Pro Logic II.
In 2-CH mode, you will hear no sound from the wireless surround speakers.
| NOTES |
If you place a speaker near your TV set, the screen colour may be distorted because of the magnetic field.
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to
the product, sound from the speakers may be disrupted because of interference.
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment or any other device that uses
the 2.4/5.8GHz frequencies near the product, sound from the speakers may be disrupted because of interference.
The maximum transmission distance from the product to the wireless receiver module is about 10m, but may vary
depending on your operating environment. If a steel-concrete wall or metallic wall is between the product and the
wireless receiver module, the system may not operate at all, because the radio wave cannot penetrate metal.
If the product doesn't make a wireless connection, you need to run an ID Set between the product and wireless
receiver module. With the product turned off, press "0"
"1"
"3"
"5" on the remote control. Turn on the wireless
receiver module. Then, press and hold the “
ID SET
” button on the back of the wireless receiver module for 5
seconds, and then turn the product on.
Attaching the Toroidal Ferrite Core to the Power Cord of the Wireless
Receiver Module (SWA-6000)
If you attach a Toroidal ferrite core to the power cord of the wireless receiver module, it
will help to prevent RF interference from radio signals.
1.
Pull the fixing tab of the Toroidal ferrite core to open it.
2.
Make a loop twice in the wireless receiver module power cord.
3.
Attach the Toroidal ferrite core to the wireless receiver module power cord as the
figure shows and press it until it clicks.
• Insert the ferrite core as close to the Wireless Receiver Module as possible.
HT-F5550W-XY_0529.indd 16
HT-F5550W-XY_0529.indd 16
2013-05-29 오후 4:50:35
2013-05-29 오후 4:50:35
