60
To listen in the auto sound calibration mode, briefly press ASC button.
(If you set the auto sound calibration in the order from 1 to 4 above for the first time)
•
The selection alternates between
ASC ON
and
ASC OFF
in the display.
•
If you select "
ASC ON
", you will hear sound in the auto sound calibration mode.
If you select "
ASC OFF
", you will hear sound in the mode set in the audio setting of the setup screen
1
Plug the auto sound calibration
microphone into the auto sound
calibration input jack.
2
Place the auto sound calibration
microphone at the listener's position.
4
5
Press ASC button.
When the message "
REMOVE MIC
"
appears in the display, unplug the auto
sound calibration microphone.
A bell sounds and the
setup finishes.
•
The tone will be output twice, in the given order (L
➝
C
➝
R
➝
RS
➝
LS
➝
SW), and 5.1-channel sound field is optimized automatically.
•
The auto sound calibration setup takes about 2 minutes to complete.
3
Adjust the volume control on the main
unit as follows:
•
If the distance between the listener and the speaker is over 16.5 feet: Set
the main unit's volume to over 25.
•
If the distance between the listener and the speaker is 10 to 16.5 feet:
Set the main unit's volume to 25.
•
If the distance between the listener and the speaker is below 10 feet:
Set the main unit's volume to 15.
To cancel the auto sound calibration setup, press ASC button.
•
The tone output stops, "
CANCEL ASC
" appears in the display followed by "
REMOVE MIC
", and the setup is cancelled.
A tone is output.
A result for each speaker is displayed.
SETUP
39P~76P(DS650)-SECA GB 11/10/04 1:16 PM Page 61
