GB
Speaker Setup
29
B
30
•
When 5.1 Channel Surround Sound is played,
you can enjoy the best sound if the distance
between you and each speaker is the same.
You can set Delay Time in the Center/Rear
Speaker to customize the sound to the
acoustics of your room.
•
Setting Center Speaker
If the distance of Dc is equal to or longer than
the distance of Df in the figure, set the mode as
0ms.
Otherwise, change the setting according to the
table on the table.
•
Setting Rear Speakers
If the distance of Df is equal to the distance of
Ds in the figure, set the mode as 0ms.
Otherwise, change the setting according to the
table.
To set the delay time
Df
Dc
Ds
Speaker Setting Methods
V I D E O
Function
Volume
Phones
Distance of (A)
50
100
400
200
Value(ms)
1.3
2.6
3.9
5.3
Distance of (B)
200
400
600
Value(ms)
5.3
10.6
15.9
(A)=Df-Dc
(B)=Df-Ds
Dc: Distance from center speaker to
listening position
Df: Distance from front speakers to
listening position
Ds: Distance from rear speakers to lis-
tening position
Ideal Center Speaker Position
Ideal Rear Speaker Position
Arrange all speakers within a circle
as shown in the figure.
Front Speakers
Center Speaker
Rear Speakers
Subwoofer Speaker
Set the front speakers so that their tweeters (high-range) are
aligned at about ear level and at a horizontal angle of 45° to
the prime listening position.
Ideally the center speaker should be positioned with its top sur-
face flush with the front speakers. However, you may place the
speaker either on top or near the bottom of your TV set.
Place the subwoofer at any convenient location within
the vicinity of the listening position.
Set the rear speakers further back parallel to the walls,
at 60 to 90 centimeters (2 to 3 feet) above prime listen-
ing position ear level.
If the space behind the listening position is insufficient
(i.e., too close to the wall), place the rear speakers fac-
ing each other on either side.
Setting up Speaker Mode
and Delay Time
•
Each time the button is pressed, a different mode selection is
displayed on the front panel display as shown below.
SPK Mode
The display changes depending on the current audio output mode
(DSP, PRO LOGIC, 3-STEREO, STEREO, etc.).
F SP SMALL
C SP SMALL
R SP SMALL
SW SP USE
C DEL
MS
R DEL
MS
D I G I T A L
L
C
R
LS
LFE
RS
D I G I T A L
L
C
R
LS
LFE
RS
D I G I T A L
L
C
R
LS
LFE
RS
D I G I T A L
L
C
R
LS
LFE
RS
D I G I T A L
L
C
R
LS
LFE
RS
D I G I T A L
L
C
R
LS
LFE
RS
S
p
e
a
k
e
r
M
o
d
e
Delay
Time
Front speaker: Small
Center speaker: Small
Rear speaker: Small
Subwoofer: Use
Center Speaker Delay Time
Rear Speaker Delay Time
C SP NONE
R SP NONE
D I G I T A L
L
C
R
LS
LFE
RS
D I G I T A L
L
C
R
LS
LFE
RS
Center speaker: Not Use
Rear speaker: Not Use
Setting up Delay Time from 00~05ms
Setting up Delay Time from 00~15ms
1
Press the Left/Right (
/
) button to select
the desired item.
Press the SPK Mode button.
▲
▲
2
•
SMALL: When this setting is selected, low frequencies of below 200 Hz are assigned to
the subwoofer only.
•
USE: Select when using speakers.
•
NONE: Select this when no speakers are installed.
