23
ENG
●
CONNECTIONS
Place the wireless receiver module at the rear of the listening position. If the wireless
receiver module is too close to the main unit, some sound interruption may be heard due
to interference.
If you use a device such as a microwave oven, wireless LAN Card or any other device that
uses the same frequency (5.8GHz) near the main unit, some sound interruption may be
heard due to interference.
The transmission distance from the main unit to the wireless receiver module is about 33
feet (10m), but may vary depending on your operating environment. If a steel-concrete wall
or metallic wall is between the main unit and the wireless receiver module, the main unit
may not operate at all, because the radio wave cannot penetrate metal.
If the main unit doesn't make wireless connection, the system needs ID Setting between
the main unit and wireless receiver module. With the main unit turned off, press the remote
control's number buttons "0"
J
"1"
J
"3"
J
"5" and the main unit will turn on. With the
wireless receiver module turned on, press "ID SET" button on the back of the wireless
receiver module for 5 seconds.
M
Do not insert any other card except the TX card dedicated to the product.
If a different TX card is used, the product may be damaged or the card may not be
removed easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the Blu-Ray Home Theater is turned off. Inserting the card when it
is turned on may cause a problem.
The wireless receiving antenna is built into the wireless receiver module. Keep the unit
away from water and moisture.
For optimal listening performance, make sure that the area around the wireless receiver
module location is clear of any obstructions.
If no sound is heard from the wireless rear speakers, switch the mode to DVD 5.1
channel or Dolby Pro Logic II .
In 2-CH mode, no sound will be heard from the wireless rear speakers.
HT-BD3252A_XAA_0627-1.indd 23
2009-07-01 6:07:40
