Connecting the TV to a SBB or STB
ETH MODEM
TV Rear Panel
STB (SBB)
Data Cable
Connect the
DATA
port of the TV to the
ETH MODEM
port of the STB (SBB) with the Data cable.
•
The
ETH MODEM
port name that you connect the Data Cable to may differ depending on the SBB or STB type.
•
IR signals sent by the remote control to the TV or SBB / STB must meet the following specification to use IR pass
through function.
IR signal reciever specification
–
Band pass filter center frequency: 37.9
㎑
–
Carrier Frequency, Duty 50%
–
Minimum Burst Length (tburst): 12 pulses (316 us)
– Minimum Gap Time Between the burst (tburst gap): 16 pulses (422 us)
– Minimum Gap Time between the data commands (tpause): 25
㎳
English - 26
