Step2. How to upgrade the Firmware by USB
1. Update the Soundbar Main Unit
1) Turn on the Soundbar and insert the USB drive into the SERVICE
port located on the bottom of the Main Unit. The software will begin to
update automatically in less than one minute.
2)
A sequence of “UPDATE” → “BYE” → “ON” will appear on the display 3 times.
3) After the 3 cycles are complete, the Soundbar will restart and last source
used will appear on the display for about 20 seconds and then it will go off
※
The time to complete step 2) will be around 10 minutes
※
Cycle and duration of update may differ by models
※
Important
: DO NOT turn off the power until the full update is complete.
[For Q90R/Q950R only]
2. Update the Subwoofer and Surround Speakers (Left / Right)
1) Disconnect and Reconnect electrical power to each component in the
following order:
Subwoofer → Left and Right Surround Speakers
2) With
the unit powered on, briefly press the “VOLUME” on the remote ( )
3)
Press and hold the “DOWN” button on the remote ( ) for about 6 seconds,
until the display shows “UPDATE”
4)
“UPDATE” → “BYE” → “ON” will appear on the display
5) After the update, the Soundbar will restart and last source used will
appear on the display for about 20 seconds and then it will go off
※
The time to complete step 3) will be around 10 minutes
※
Important
: DO NOT turn off the power until the full update is complete.
(“UPDATE → BYE → ON“) 3 times → “D.IN” → OFF