72
_ troubleshooting
surface burners do not
light.
The control knob is not set
properly.
Push in the control knob and
turn it to the LITE position.
Burner caps not in place
Burner base misaligned
Clean electrodes.
Put the burner cap on the burner
head Make burner base aligned
surface burner clicks
during operation.
The control knob has been left in
the LITE position.
After the burner lights, turn the
control knob to a desired setting.
If the burner still clicks, contact a
service technician.
the burners do not burn
evenly.
Surface burner components
and grates are not assembled
correctly and level.
See the Installation Instructions.
Surface burners are dirty.
Clean surface burner
components. (See pages 58
and 59.)
Very large or yellow
surface burner flames.
The air-gas ratio is not correct.
Contact your installer. The burner
manifold ports may need to be
changed to correct the ratio or
for LP gas conversion.
surface burners light
but oven burners do not
light.
The oven control lockout is
turned on.
The display will show the Lock
icon. Hold the oven door open
and press the CONTROL/DOOR
LOCK pad for 3 seconds. The
oven will beep and the Lock icon
will turn off.
Gas Pressure Regulator shut off
switch is in the ‘off position.
Call a qualified service
technician.
Display goes blank.
The electrical outlet Ground Fault
Interrupter (GFI or GFCI) has
been tripped and needs to be
reset.
Your digital control has been
damaged.
Replace fuse or reset circuit
breaker.
Very large or yellow
oven burner flames.
The oven burner air adjustment
shutters need to be adjusted.
Call for a qualified service
technician.
Gas supply is not properly
connected or turned on.
See the Installation Instructions
that came with your range.
food does not bake or
roast properly in the
oven.
The oven controls have not been
set properly.
See control function instructions
in this manual.
The oven racks have not been
positioned properly for the foods
being cooked.
See page 30.
Incorrect cookware or cookware
of improper size being used.
See page 24.
Oven thermostat needs
adjustment.
See page 33.
There is aluminum foil on racks
and/or oven bottom.
Remove foil.
Clock or timers not set correctly.
See pages 28 and 29.
FX710BGS_FX510BGS_DG68-00356A-01.indd 72
2011-08-19 �� 4:26:04