installing the dishwasher
_21
02 INS
T
ALLING THE DISHW
ASHER
STEP 12
COMPLETING THE INSTALLATION
1.
Open the door and remove all foam, paper packaging, and unnecessary parts.
2.
Turn on the circuit breaker you turned off before you began the installation.
3.
Open the water supply valve to supply water to the dishwasher.
4.
Turn on the dishwasher, and then select and run a cycle.
Check if the power turns on correctly and if there is any water leakage while the dishwasher
is operating. If no errors occur while it is operating, turn off the dishwasher, and then go to
Step 5 below.
If an error has occurred, turn off the dishwasher, close the water supply valve, and then
refer to the user manual or contact a service center 1-800-SAMSUNG (726-7864).
Make sure to check for water leakage on both ends of the water supply line and drain hose
connector.
CAUTION
Installation_DD81-02034B-00_EN.indd Sec3:21
Installation_DD81-02034B-02_EN.indd Sec3:21
/10/2016 10:56:06 AM
255/08/2017 10:56:06 AM
5.
Confi rm that the kick plate gasket is on the bottom of the kick plate. Insert the rubber skirt
behind the kick plate, and tighten the kick plate using the screws included in the Install Kit.
See the fi gures below for reference.
