English - 11
6
Sanitize /
( Control Lock)
With the
Sanitize
option selected, the water temperature is increased to 163 ˚F (73 ˚C) in the
fi nal rinse cycle for high temperature sanitization.
If you select the
Sanitize
option, the "Sanitize" lamp blinks when the water temperature reaches
the sanitary temperature (over 155 ˚F (68 ˚C)), and then remains illuminated until the
Sanitize
option ends. When you open the door or press the
Power
button, the "Sanitize" lamp turns off .
You cannot select the
Sanitize
option if you select the
Delicate
and
Rinse Only
cycles.
The Sanitize feature operates in accordance with NSF/ANSI Standard 184 for Residential
Dishwashers. Certifi ed residential dishwashers are not intended for licensed food
establishments. Your dishwasher is NSF Certifi ed.
Only the
Heavy
cycle with the
Sanitize
option has been designed to meet the requirements for
soil removal and sanitization effi cacy in NSF 184.
Control Lock allows you to lock the buttons on the control panel so children cannot accidently
start the dishwasher by pressing the buttons on the panel.
To lock and unlock the buttons on the control panel, hold the
Sanitize
button down for three (3)
seconds when the power is On.
7
Display
Displays cycle time and remaining hours and minutes,
Delay Start
hours, and Information
codes. If a problem occurs during operation, an information code appears with a warning
sound. Refer to the information codes page.
Control Lock indicator
-
Turns on if the Control Lock is set (or the dishwasher is in the standby or pause
modes).
- Turns
off while the dishwasher is operating.
-
When Control Lock is on, the Control Lock indicator blinks for several seconds if any
button except the
Power
button is pressed.
Self Clean indicator
-
Turns on when the
Self Clean
option is enabled (or the dishwasher is in the standby
or pause modes), but turns off while the dishwasher is operating.
-
Blinks for 5 seconds every 20 to 22 cycles.
-
The cycle counter disappears when the Self Clean operation is complete or when
the dishwasher reaches the 23rd cycle without the
Self Clean
cycle being used.
(The
Cancel
or
Self Clean
operation is not counted by the cycle counter.)
Rinse Refi ll indicator
-
Turns on if the dishwasher runs out of rinse aid (or the dishwasher is in the standby
or pause modes).
- Turns
off while the dishwasher is operating.
8
Delay Start
Delay a cycle for up to 24 hours in one-hour increments. To increase the delay start time, press
or hold the
Delay Start
button. The hour displayed indicates the time at which the wash will
start.
-
After setting the delay time, press the
Start
button, and then close the door to start the
cycle.
-
If you want to change the delay time once the dishwasher has started, press the
Cancel
button and turn off the dishwasher. Then, turn on the dishwasher again and select a new
cycle with a new delay setting.
9
Smart Control
To connect the dishwasher to your smart phone, use this option.
For details, see page
16
.
To connect the dishwasher to your smart phone the fi rst time. press and hold
Smart Control
to start the
AP
mode in the dishwasher.
03 using your dishwasher
DW9900M-00184A-00_EN.indd 11
DW9900M-00184A-00_EN.indd 11
2016-12-12 2:47:50
2016-12-12 2:47:50
