Cleaning and care
_25
06 CLEANING AND C
ARE
CLEANING THE SPRAY ARMS
It is necessary to clean the spray arms regularly as hard water chemicals may
clog the spray arm jets and bearings. To remove the middle spray arm, hold the
nut, rotate the arm clockwise to remove it. To remove the lower spray arm, pull
out the spray arm upward. Wash the arms in soapy and warm water and use a
soft brush to clean the jets. Replace them after rinsing them thoroughly.
Open
CLEANING THE DOOR
To clean the edge around the door, you should use only a soft warm, damp rag.
To prevent penetration of water into the door lock and electrical components,
do not use a spray cleaner of any kind.
Also, never use abrasive cleaners or scouring pads on the outer surfaces
because they will scratch the finish. Some papers towels can also scratch or
leave marks on the surface.
WARNING
: Never use a spray cleaner to clvean the door panel for it could damage the door lock and
electrical components. It is not advised to use the abrasive agent or some paper towel because of the
risk of scratching or leaving spots on the stainless steel surface.
CARING FOR THE DISHWASHER
To clean the control panel use a lightly damp cloth then dry thoroughly. To clean the exterior use a good
appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
PROTECT AGAINST FREEZING
If your dishwasher is left in an unheated place during the winter:
1.
Cut off electrical power to the dishwasher.
2.
Turn off the water supply and disconnect the water inlet pipe from the water valve.
3.
Drain water from the inlet pipe and water valve. (Use a pan to catch the water)
4.
Reconnect the water inlet pipe to the water valve.
5.
Remove the fi lter in the tub the bottom and use a sponge to use up water in sump.
DD81-01624B-03_EN (South Africa)_160124.indd 25
DD81-01624B-03_EN (South Africa)_160124.indd 25
2016-01-24 6:04:25
2016-01-24 6:04:25
