Installation
Installation
English
24
Step-by-step installation
Make sure you have a qualified technician install the dryer. Step by step installation
instructions start below.
• Do not remove the protective film on the door before completing the product
installation. If you remove the protective film before the installation is complete, the
door may get scratched or damaged during installation.
• Make sure the installation location allows enough space for the dryer door to be fully
open.
STEP 1
Install the exhaust system
1.
Select a location and move the dryer to the site. For easy access, we recommend you
install the dryer in the same location as your washer.
2.
To change the door direction, see “
3.
Install the exhaust system as instructed in the “
” section.
CAUTION
Before installing your dryer, remove the packing in the duct.
NOTE
• To move the dryer easily, lay two of the carton cushion-from the packaging on the
floor. Tip the dryer on its side so it lies across both cushion-tops. Push the dryer so that
it is near its final location, and then set the dryer upright.
• Secure room around the dryer to facilitate ducting and wiring.
STEP 2
Connect the gas line
Before connecting the gas line, make sure you have read the “
” section
.
1.
Remove the protective cap from the gas pipe.
2.
Apply a LPG (Liquefied Petroleum Gas)-safe compound or 1.5 wraps of Teflon tape to
all threaded connections.
3.
Connect the gas supply to the dryer. An additional fitting is required to connect the
3
/
4
”
(1.9 cm) female thread end of a flexible connector to the
3
/
8
” (1 cm) male threaded end
on the dryer. Tighten up the fitting over all threads.
4.
Turn on the gas supply, and check for any leaks using a soap solution. If a leak is found,
tighten the connections and try again.
DO NOT
use an open flame to check for gas
leaks.
DV3200T_DC68-03784N-00_EN.indd 24
2020-05-25 11:10:20
