English
-
14
installing your dryer
Connecting the drain hose
Do not extend the drain hose.
- Since water may leak from the connected part, be sure to one long drain hose instead of
connecting short ones. If you cannot help connecting more than one hose, be sure to seal
the connected parts with silicone sealant. (Do not use the electric insulating tape for sealing.)
The end of the drain hose can be positioned in three ways:
1.
Over the edge of a wash basin:
The drain hose must be placed lower than 90cm. If the end
of the drain hose needs to be placed above the ground, we recommend a height of 60cm ~
90cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure the
guide to the wall with a hook or to the tap with a piece of string to prevent the drain hose
from moving.
2.
Assemble the drain hose and the hose guide and fi x them with the cable-tie.
3.
You can drain the condensed water by connecting the accessory hose (long drain hose) to
the drain-outlet directly.
Connecting the direct-hose
You can immediately drain the condensed water that comes out while drying, by connecting the
drain hose to the tap.
1.
Assemble the hose connector and the hose.
Since there is a danger of water leaking from the hose
connecter and accessory hose, make sure that they are
connected fi rmly.
2.
Connect the end of the hose to the tap.
CAUTION
CAUTION
Hose Connecter
Drain hose
Hose guide
90 cm
Cable Tie
DV90F5E6HGW-03297A-07_EN.indd Sec3:14
DV90F5E6HGW-03297A-07_EN.indd Sec3:14
2014-11-12 7:54:47
2014-11-12 7:54:47