Troubleshooting _ 27
4-2. TEST MODE
Data display mode
How to enter:
•
After turning on the dryer, press
Drylevel
Time
Temp
Time
within 2 seconds to enter the display
mode.
•
To change the mode, use the cycle selector.
Display mode number
1
Main micom version
2
Display micom version
3
Touch-sensitive module version
4
Option value
5
Temperature data
6
Average temperature data for
1 minute
7
Temperature data for detecting
if the vent is clogged
8
Average touch sensor data for
1 minute
9
Cycle count
Error Recall
Error Recall mode reminds users of the last error that was detected. Press and hold both the
and
Dry Level
buttons for 8 seconds to enter this mode. In Error Recall mode, the last error
that was detected appears. If no error has been found, nothing is displayed.
Smart Install
Smart Install allows service personnel to check if the dryer is installed properly.
To enter Smart Install
Turn on the dryer, and press and hold the Adjust
Time Up
+
Temp
buttons for 7 seconds.
A message of
“SC”
appears.
Step 1.
Check the touch sensor
Enter Smart Install mode, and open the door. The state of the touch sensor appears.
- 0
: Touch sensor open
- 1
: Touch sensor short
Put a wet cloth on the touch sensor to display
“1”
. Removing the cloth displays
“0”
.
Step 2.
Check the motor and heater
Press the
Start
button to enter the diagnosis mode. The diagnosis result appears.
- OK
: Both motor and heater work normally
- HC
: Motor or heater doesn’t work normally
