DSR 9500A FT
A, CI, EM VIA, VIA CI
GB-28
D
I
G
I
T
A
L
S
A
T
E
L
L
I
T
E
R
E
C
E
I
V
E
R
DSR 9500A FT
A, CI, EM VIA, VIA CI
GB
GB-29
5. Common Interface
(Only for DSR 9500A VIA CI, DSR 9500A CI)
This STB is equipped with two PCMCIA slots,
which enable the use of two CI-CAMS.
When a Common Interface CAM is inserted inside
the PCMCIA slot,
the system detects the type of the CAM automatically
and display in the main menu.
On choosing this menu, you will be able to access
the different options available with the type of the
CAM like authorizations, pre-booking, package
details etc.,
SLOT A:
You can see the Common Interface CAM’s name
which has been inserted.
SLOT B:
"
Not installed
" is displayed when there is no CAM in slot.
6. Embedded Viaccess
(Only for DSR 9500A VIA CI, DSR 9500A EM VIA)
1. Change PIN code:
Change the PIN code of the Smartcard,
if necessary.
2. Change Parental Rating:
Change the setting for the family filter,
if necessary.
N
No
otte
e
:
This service is not offered by all channels.
3. Change Lock indicator:
You can change the lock status of the
Viaccess Smartcard.
4. Issuer Information:
Here you can call up all information stored on
the Smartcard by the publisher.
5. Authorization:
This option would indicate the authorization status
of the Smartcard.
4.6 System Information
If you have to contact your service provider or a service
center they might ask for information available from this menu.
Place the cursor on this sub menu and press
key.
The following will be the on-screen display.
4.7 Software Upgrade
You can download and upgrade the software of this
STB
through ASTRA, Sirius and Hotbird satellite when
the new software is released.
During downloading don’t turn off the
STB
.
If there is a new version of software to download,
you are asked if you will update or not.
If you press
key, the update starts right away.
In case update is impossible, you get this message
"
You can’t update software!
" Or in case you don’t
need to update, "
You don’t need to update software!
"
will be displayed.
4.8 Copy Channel Data
(Only for DSR 9500A CI, DSR 9500A FTA)
If you want to copy the channel data from one receiver
to another, please follow the instruction below.
Please make your own channel data, such as favorite
& lock channel with your own master box.
Then take your master box when you install another box.
1. Plug on both master & slave receivers
2. Master Box(Installed Box) : Stand-by Mode
3. Slave Box(Installing Box) : Menu Mode
4. Connect 2 Boxes with RS232 serial cable
(Both end should have male connector)
5. Select '
4. System Setup
'
6. Press '
7
' key on RCU
7. Press '
OK
' to start channel data copy
N
No
otte
e
:
Use this function after removing SMART CARD or CAM modules.
OPERATING THE RECEIVER
OPERATING THE RECEIVER
DSR 9500A_GB_10.10 10/12/02 9:15 AM Page 28
