08_
setting up
When the Fridge part is lower than the
Freezer part.
Insert a fl at-head screwdriver into the hole of the
adjustable leg at the bottom of the refrigerator door
and turn it clockwise.
Refer to the next section for the best way
to Adjust the height difference between
doors.
ADJUSTING THE HEIGHT
DIFFERENCE BETWEEN DOORS
If one door is lower than the other.
You can use the
•
adjustable nut at the
bottom of the fridge/
freezer to adjust the
height difference
between the doors.
An excessive adjustment
•
may cause interference between the door and
the top hinge while opening/closing the door.
Open the door to adjust it. Use the provided
1.
wrench to turn the bottom adjustable nut (
a
)
as far clockwise (
) as necessary.
Open the door and make adjustments
inside the door.
Use the provided wrench to turn the height
2.
adjustable nut (
b
) as far counter clockwise
(
) as necessary.
(Turn it counter clockwise (
) to lift the
door up; turn it clockwise (
) to lower the
door.)
When the height is aligned on both sides,
3.
use the wrench to turn the adjustable nut (
a
)
counter clockwise (
) to tighten it.
If you adjusted the height of the product
while it is empty, adding food later may
eventually cause a height difference due to
the added weight. If this is the case, follow
the steps above to adjust the height again.
SETTING UP THE REFRIGERATOR
Now that you have your new refrigerator installed
and in place, you are ready to set up and enjoy the
full features and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
If not, fi rst check the power supply and electricity
source or try the troubleshooting section at the
back of this user guide.
If you have any further questions, contact your
Samsung Electronics call center.
Place the refrigerator in an appropriate location
1.
with reasonable clearance between the wall and
the refrigerator.
Refer to installation instructions in this manual.
Once the refrigerator is plugged in, make sure
2.
the interior light comes on when you open the
doors.
Set the temperature control to the coldest
3.
temperature and wait for an hour.
The freezer should get slightly chilled and the
motor should run smoothly.
After powering the refrigerator, it will take a few
4.
hours to reach the appropriate temperature.
Once the refrigerator temperature is suffi ciently
cool, you can store food and drink in the
refrigerator.
DA99-03327N-1 EN.indd 08
DA99-03327N-1 EN.indd 08
2012.3.5 4:55:52 PM
2012.3.5 4:55:52 PM
