8
GB
What to Do if You are in Doubt or You have a
Problem
Becoming familiar with a new appliance always takes a little time. If you
have any of the problems listed below, try the solutions given. They may
save you the time and inconvenience of an unnecessary service call.
◆
The following are normal occurrences.
•
Condensation inside the oven
•
Air flow around the door and outer casing
•
Light reflection around the door and outer casing
•
Steam escaping from around the door or vents
◆
The food is not cooked at all
•
Have you set the timer correctly and pressed the
Start
(
) button?
•
Is the door closed?
•
Have you overloaded the electric circuit and caused a fuse to blow or a
breaker to be triggered.
◆
The food is either overcooked or undercooked
•
Was the appropriate cooking length set for the type of food?
•
Was an appropriate power level chosen?
◆
Sparking and cracking occur inside the oven (arcing)
•
Have you used a dish with metal trimmings?
•
Have you left a fork or other metal utensil inside the oven?
•
Is aluminium foil too close to the inside walls?
◆
The oven causes interference with radios or televisions
•
Slight interference may be observed on televisions or radios when the oven is
operating. This is normal.
*
Solution: Install the oven away from televisions, radios and aerials.
•
If interference is detected by the oven’s microprocessor, the display may be
reset.
*
Solution: Disconnect the power plug and reconnect it. Reset the time.
◆
“E3" message indicates
•
The "E3" message is automatically activated prior to the microwave oven
overheating. Should the "E3" message be activated, then depress the "
"
key to utilize the initialization mode.
If the above guidelines do not enable you to solve the problem, then
contact your local Samsung customer service centre.
Please have the following information read;
•
The model and serial numbers, normally printed on the rear
of the oven
•
Your warranty details
•
A clear description of the problem
Then contact your local dealer or SAMSUNG aftersales service.
Cooking/Reheating
The following procedure explains how to cook or reheat food.
☛
ALWAYS check your cooking settings before leaving the oven
unattended.
Open the door. Place the food in the centre of the turntable. Close the
door. Never switch the microwave oven on when it is empty.
Quick Start:
✉
If you wish to heat a dish for a short period of time at maximum
power (900W), you can also simply press the
+30s
(
)
button
once for each 30 seconds of cooking time. The oven starts
immediately.
1.
Turn the
Control knob
to the
Microwave
(
) symbol.
Result:
The following indications are displayed:
(one-stage
cooking)
(microwave
mode)
2.
Select the appropriate power level by pressing the
Select
(
) button again until the corresponding output power is
displayed. Refer to the power level table below for further
details.
3.
Set the cooking time by turning the
encoder dial
.
•
Example: For a cooking time of 3 minutes, 30 seconds,
turn the encoder dial to the right to set 3:30.
Result:
The cooking time is displayed.
4.
Press the
Start
(
) button.
Result:
The oven light comes on and the turntable starts
rotating. Cooking starts and when it has
finished:
◆
The oven will beep and flash “0” four times.
The oven will then beep one time per minute.
✉
If you would like to know the current Power
Level of the oven cavity, press
Microwave
(
)
button once. If you would like to change the
power level during cooking, press the
Microwave
(
)
button twice or more times to
select the desired power level.
jlXXWWniUGGwG_GG{ SGt GXZSGYWW[GG`aY`Ght
