Appendix
34
English
Before Requesting Service
Pollution level
The fan speed does not change when the pollution level
changes.
•
Set the fan speed to Auto. The fan speed does not change
automatically when it is set to Low , Medium, or High or when
the Wind-Free or Sleep mode is running.
The PM10, PM2.5, PM1.0 levels do not change from Good (05).
•
This may happen when the room is properly sealed and the air
is clean.
To check if the sensor is functioning, test it by tearing paper by
the sensor and/or rub them to create some dust. This will cause
the PM levels to change if the sensor is working properly.
–
Dusting off or cleaning the room may not necessarily cause
sensor feedback if the dust particles are bigger than PM10,
while they are still filtered and removed from the air.
The PM10, PM2.5, PM1.0 levels the all same.
•
When the air is clean, you may not see a difference between
the PM10, PM2.5 and PM1.0 levels. To check if the sensor is
functioning, test it by tearing paper by the sensor and/or rub
them to create some dust. This will cause the PM levels to
change if the sensor is working properly.
Display
The filter replacement indicator is always turned on.
•
Replace the filters with new ones, and then press and hold
the [
] button for 3 seconds or more to reset the filter
replacement reminder.
Strange indications appear on the display.
•
If any of the indications
C103, C154, C162, C163
appears,
contact a Samsung Service Center.
DB68-08449A-03_IB_ACR AX9500_AA_EN.indd 34
2020-11-27 오후 6:10:17
