E-
20
Drain Hose Installation
Care must be taken when installing the drain hose for the indoor unit to ensure that any condensation water is
correctly drained outside. When passing the drain hose through the 65 mm hole drilled in the wall, check that none
of the following situations occur.
Shield
Drain hose
Extension drain hose
The hose must NOT
slope upwards.
The end of the drain
hose must NOT be
placed in water.
Do NOT bend the
hose in different
directions.
Keep a clearance of at
least 5-cm between
the end of the hose
and the ground.
5cm
less
Do NOT place the end
of the drain hose in a
hollow.
Ditch
To install the drain hose, proceed as follows.
1
If necessary, connect the 2m extension to the drain hose.
2
If you are using the extension, insulate the inside part of the extension drain
hose with a shield.
3
Pass the drain hose under the refrigerant piping, taking care to keep the drain
hose tight.
4
Pass the drain hose through the hole in the wall, making sure that it is sloping
downwards, as shown in the illustrations above.
AVXWH@@_IM_E_24119-1.indd 20
2006-01-04 ¿ÀÈÄ 6:03:19
Summary of Contents for AVXWH series
Page 29: ...E 29 ENGLISH Memo ...
Page 30: ......
