E-
20
Drain pipe and Drain hose Installation (Continued)
Water supply intake
Prepare a little water about 2 liters.
Open the cover of water supply intake by turning and pulling the cover.
1
Confirm that the water flows out through the drain hose.
3
When the drain pump is installed, operate the unit as cooling mode and
check a drain pump pumping.
4
Testing the drainage
Pour water into the the indoor unit as shown in figure.
2
If you do not pour water inside the water supply intake, water
may spill from the indoor unit.
Note
Reassemble the cover of water supply intake.
7
Check drain water drops at the end of the drain pipe.
5
Make sure there is no water leak at the drainage.
6
Drainpipe
Drain water drops
AVXDS@@_IM_E_30798-1_8.31.09.indd 20
2009-8-31 10:27:22
