Samsung AJ BNHDCH Series, Installation Manual

Page: 25 / 36

25
Installation Pr
oc
edur
e
English
Step 18 Optional : Setting the indoor unit
addresses and the installation options with
wireless remote controller
You cannot set both the indoor unit addresses and the
installation options at the same time.
Receiver & display unit must be connected to the indoor unit to
set options with the wireless remote control.
Common steps for setting the addresses and options
Low Temp button
High Temp button
Mode button
Low Fan button
High Fan button
Setting the
option values
Entering the mode
for setting the
options
NOTE
• The remote control display and buttons may vary depending
on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
and then insert them again.
b While holding down the (High Temp) and
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
2 Set the option values.
CAUTION
• The total number of available options are 24: SEG1 to SEG24.
• Because SEG1, SEG7, SEG13, and SEG19 are the page options
used by the previous remote control models, the modes to
set values for these options are skipped automatically.
• Set a 2-digit value for each option pair in the following order:
SEG2 and SEG3
ĺ
SEG4 and SEG5
ĺ
SEG6 and SEG8
ĺ
SEG9 and SEG10 ĺ SEG11 and SEG12 ĺ SEG14 and SEG15 ĺ
SEG16 and SEG17
ĺ
SEG18 and SEG20
ĺ
SEG21 and SEG22
ĺ SEG23 and SEG24
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 X X X X X
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 X X X X X
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2 X X X X X
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3 X X X X X
On (SEG1 to SEG12) Off (SEG13 to SEG24)