4
f
Make sure to safely dispose of packing materials. Packing materials, such as nails and other metal or wooden pallets may
cause children get injured.
f
Inspect the product shipped and check if damaged during transport. If the product has some damages, DO NOT INSTALL
and immediately discuss about the damages with the carrier or retailer (if the installer or the authorized technician has
collected the material from the retailer.)
f
Our units shall be installed in compliance with the spaces described in the installation manual, to ensure accessibility
from both sides and allow repairs or maintenance operations to be carried out. If the units installed without complying
with procedures described in manual, additional expenses can be asked because special harnesses, ladders, scaffolding
or any other elevation system for repair service will NOT be considered part of the warranty and will be charged to the
end customer.
f
Always make sure that the power supply is compliant with local safety standards.
f
Verify that the voltage and frequency of the power supply comply with the specifications and input power is sufficient to
ensure the operation of any other domestic appliance connected to the same electric lines. Always verify that the cut-off
and protection switches are suitably selected.
f
Always verify that electric connections (cable entry, section of leads, protections…) are compliant with the electric
specifications and with the instructions provided in the wiring scheme. Always verify that all connections comply with
the standards applicable to the installation of air to water heat pumps. Devices disconnected from the power supply
should be completely disconnected in the condition of overvoltage category.
f
Do not connect the earth wire to the gas pipe or water pipe, lighting rod, surge absorber, or telephone earth wire. If
earthing is not complete, it may cause an electric shock or fire.
f
Be sure to install both an earth leakage detector and circuit breaker with specified capacity in accordance with relevant
local and national regulations.
- If it is not installed properly, it may cause electric shocks and fire.
f
Make sure that the condensed water runs well out of the unit at low ambient temperature. Drain pipe and cond heater
can frost/ice can not grow. If drain work is not effective for releasing condensed water, it can make the units get damaged
by massive ice and system can be stop , covered by ice.
f
Install the power cable and communication cable of the indoor and outdoor unit at least 1m away from the electric
appliance.
f
Protect the unit from rats or small animals. If an animal makes a contact with the electric parts, it can cause malfunctions,
smoke or fire. Please instruct the customer to keep the area around the unit clean.
f
Do not disassemble and alter the heater at your own discretion.
f
Be sure not to perform power cable modification, extension wiring, and multiple wire connection.
- It may cause electric shock or fire due to poor connection, poor insulation, or current limit override.
- When extension wiring is required due to power line damage, refer to “How to connect your extended power cables” in
the installation manual.
f
Do not use means to accelerate the defrost operation or to clean, other than those recommended by Samsung.
f
Do not pierce or burn.
f
Be aware that refrigerants may not contain an odour.
Safety precautions
